top of page
SOA Zippo Lighter.png

DRAFT 21 Term Project

My reverse engineering project is based on a Zippo Lighter. 

Partial knolling

01

Week 1 Progress

This week I spent a lot of time disassembling my Zippo lighter, measuring, sketching and researching. 

02

Week 2 Progress

This week I modeled most of the parts for my assembly. I focused on modeling the most of what I could so I can do the drawings next. 

IMG_5545.HEIC
INNER BODY SECOND DRAFT.png

03

Week 3 Progress

This week I began to do my drawings and finalized all of my existing parts that I had modeled. It took a while, and lots of strength, but I was able to take apart the last component I needed to disassemble. 

©2022 by DaisyTG

bottom of page